General
Display
Performance
Camera
Battery
Network
Connectivity
Sensors
Other
Cubot KingKong ES 3 Overview
The Cubot KingKong ES 3 is an Android device from Cubot, released in 2025. It combines the Unisoc T615 (12 nm) and a 6.75-inch display, running Android 15. This page tracks its full specifications, root status, and the bootloader and recovery notes that apply to it.
Root the Cubot KingKong ES 3
The Cubot KingKong ES 3 is a 2025 Android device from Cubot. It runs the Unisoc T615 (12 nm), a Unisoc platform with thinner community tooling — extra caution warranted. Shipped software: Android 15. For this model the realistic path is: a standard fastboot bootloader unlock, followed by Magisk via patched init_boot image (fastboot). Typical hands-on time is 2–4 hours (after eligibility check).
Difficulty
Advanced — verify unlock eligibility first
Typical time
2–4 hours (after eligibility check)
Method
Magisk via patched init_boot image (fastboot) — KernelSU also viable (GKI kernel)
Bootloader unlock on Cubot
Unlock procedure follows the generic Android flow: enable OEM Unlocking in Developer Options, then unlock via fastboot. Exact availability depends on the model and region — confirm before flashing.
Platform notes
Unisoc platforms have thinner community tooling than Qualcomm or MediaTek; unlock and flash procedures exist for many models but documentation is sparse — verify your exact variant before flashing anything.
Before you start
- Bootloader unlocking factory-resets the device on almost all models — back up everything first.
- As a device launched on Android 15, the Magisk target is typically init_boot.img, not boot.img — patching the wrong image is the top bootloop cause on newer models.
FAQ
Can I root the Cubot KingKong ES 3?
Only if this exact model and region are eligible for a bootloader unlock. Unlock procedure follows the generic Android flow: enable OEM Unlocking in Developer Options, then unlock via fastboot. Exact availability depends on the model and region — confirm before flashing. Once an unlock is approved, root is Magisk via patched init_boot image (fastboot).
Does the Cubot KingKong ES 3 support custom recovery (TWRP)?
That depends on community support for this exact model — verify a build exists for its codename before flashing anything. TWRP is not required for root: Magisk installs by flashing a patched init_boot image via fastboot.
Will root the Cubot KingKong ES 3 void my warranty?
Cubot will generally treat a rooted Cubot KingKong ES 3 as outside warranty while it is modified. Restoring full stock firmware before a service visit usually restores normal treatment in practice, and consumer law in some regions (such as the EU) may still cover defects unrelated to root.
What Android version does the Cubot KingKong ES 3 run?
It runs Android 15. The specifications table on this page lists the full software details.
Similar Devices
Cubot Beatbox
Cubot GT5
Cubot Tab KingKong Mini
Cubot Tab KingKong S
Cubot Note 60
Cubot KingKong Ace 5
Cubot X100
Cubot KingKong Mini 4